Honeywell ACS-8, Installation Instructions Manual

Page: 87 / 142

Installation Instructions / ACS-8 87
3
Except potetial separation module. There the LEDs indicate the communication between ACS-8 and module
bus participants.
For details see mounting and connection instaructions of potential separation module, P32508-10-002-xx.
Functions of the LEDs and the buzzer of ACS-8 and module bus participants
3
LED/buzzer State Meaning
Normal (green)
Off No operating voltage
Slow flashing Not parameterized
Fast flashing Parameterization running
On Ready
Fault (yellow)
Off No fault
On Battery/battery fault
Line failure
Central reset Without storing
(except for central reset)
Tamper (red)
Off No tamper
On Tamper With storing
Alarm (red)*
Off No alarm
On Number of incorrect attempts
Unauthorized opening or door was open too
long With storing
Alert (red)*
Off No message
On Threat With storing
Buzzer
Off No message or manually reset
Fast interval Tamper/alarm With storing
On Line/battery/battery failure Without storing
The cancel buzzer push-button makes it possible to reset the buzzer manually. To do so, press the push-
button at least for 3 seconds with a suitable object.
* Not available at module bus participants (door module, input module, output module, in/output module).
Meaning of the LEDs of AC readers
LED colour Basic state After reading a data carrier Meaning
yellow on Ready to read
yellow off - Device is dead voltage
- Controller is not parapeterized
- PIN- or door code entry is active
yellow flashing Reader is not allocated to any door
green on Permanent release
red on Permantent blocked
green on Door release
red on ID card not authorized
red flashing Read error
Additionally, the key and LED functions of the macro control of IQ MultiAccess are valid (see separate
manual "Supplementary Functions of IQ MultiAccess", P32205-46-0G0-xx).