27
“transportable” installation type
With this installation type the product is equipped with a pedestal. It can be installed and operated at any location.
Please observe the values for the maximum submersion depth and the minimum water coverage, and remember
that the surfaces of the product become very hot.
“S1” operating mode (continuous operation)
At the rated load, a constant temperature is reached that does not increase even in prolonged operation. The
operating equipment can operate uninterruptedly at the rated load without exceeding the maximum permissible
temperature.
“S2” operating mode (short-term operation)
The operating time is specified in minutes, for example, S2-20. That means, that the machine can work 20
minutes and should pauses after it, as long as the machine is cooled down to 2K over medium temperature.
Operating mode "S3" (intermittent operation):
For these operating modes, after the abbreviation, the duty cycle is displayed as well as the cycle duration if it
deviates from 10 minutes. Example S3 30% means, that the machine can work 3 minutes and afterwards should
pauses 7 minutes.
“Sip operation”
Siphoning operation is similar to dry running. The product operates at full speed, but only small amounts of liquid
are pumped.
Sip operation is only possible with certain types; see the “Product description” chapter.
Dry-run protection
The dry-run protection is designed to automatically shut down the product if the water level falls below the
minimum water coverage value of the product. This is made possible by installing a float switch.
Level control
The level control is designed to switch the product on or off depending on the filling level. This is made possible
by installing a float switch.
2. Safety
This chapter lists all the generally applicable safety instructions and technical information. Furthermore, every
other chapter contains specific safety instructions and technical information. All instructions and information must
be observed and followed during the various phases of the product's lifecycle (installation, operation,
maintenance, transport etc.). The operator is responsible for ensuring that personnel follow these instructions and
guidelines.
2.1. Instructions and safety information
This manual uses instructions and safety information for preventing injury and damage to property.
To make this clear for the personnel, the instructions and safety information are distinguished as follows:
Each safety instruction begins with one of the following signal words:
Danger:
Serious or fatal injuries can occur!
Warning:
Serious injuries can occur!
Caution:
Injuries can occur!
Caution (Instruction without symbol):
Serious damage to property can occur, including irreparable damage!
Safety instructions begin with a signal word and description of the hazard, followed by the hazard source and
potential consequences, and end with information on preventing it.
2.2 Guidelines used and CE certification
Our products are subject to
- various EC directives
- various harmonized standards
- various national standards.
Summary of Contents for H832-15/0,37W
Page 42: ...42...
