Chapter 6 Maintenance and Inspection
6.5 Method of Checking the Inverter and Converter Circuits
You can check the quality of the inverter and converter circuits by using a tester.
(Preparation)
1) Remove the external power supply cables from terminals R, T, and T, the motor cables from terminals
U, V, and W, and the regenerative braking resistor cables from terminals P and RB.
2) Prepare a tester. (Use the 1
Ω
-measuring range.)
(Checking method)
Measure the current conduction at each of the inverter's main circuit terminals R, S, T, U, V, W, RB, P, and
N while switching the tester polarity alternately.
Note 1: Before checking the circuits, measure the voltage across terminals P and N with the tester in DC
voltage range mode to confirm that the smoothing capacitor has fully discharged electricity.
Note 2: When the measured terminal is nonconductive, the tester reads a nearly infinite resistance. The
tester may not read the infinite resistance if the measured terminal flows a current momentarily
under the influence of the smoothing capacitor.
When the measured terminal is conductive, the tester reading is several ohms to several tens of
ohms. The measured values may vary slightly, depending on the types of circuit devices and
tester. However, if the values measured at the terminals are almost the same, the inverter and
converter circuits have adequate quality.
Note 3: Only inverter models with capacity of 22 kW or less have the BRD circuit.
Tester polarity
⊕
(red)
\
(black)
Measurement result
R PD
Nonconductive
D1
PD R
Conductive
S PD
Nonconductive
D2
PD S
Conductive
BRD circuit
6 - 4
Inverter circuit
T
S
R
PD
D1
D4
D2
D5
D3
D6
TR4 TR5 TR6
TR1 TR2 TR3
W
V
U
C+
N
P
RB
Converter circuit
TR7
T PD
Nonconductive
D3
PD T
Conductive
R N
Conductive
D4
N R
Nonconductive
S N
Conductive
D5
N S
Nonconductive
T N
Conductive
Converter circuit
D6
N T
Nonconductive
U P
Nonconductive
TR1
P U
Conductive
V P
Nonconductive
TR2
P V
Conductive
W P
Nonconductive
TR3
P W
Conductive
U N
Conductive
TR4
N U
Nonconductive
V N
Conductive
TR5
N V
Nonconductive
W N
Conductive
Inverter circuit
TR6
N W
Nonconductive
RB P
Nonconductive
P RB
Conductive
RB N
Nonconductive
BRD c
ir
c
uit
TR7
N RV
Nonconductive
Summary of Contents for SJ700-055HFF2
