Hioki 8910, Instruction Manual

Page: 43 / 150

35
3.5 Operation Map
1. When the [ CAL ] key is pressed in CAL mode during CAL signal
output
2. When the label, output format, or bit position is being selected in
setting mode
3. When the instrument is engaged in RS communication
4. When an error message is displayed
5. When the instrument is in system reset mode
Setting change
Operation tips
CAN conversion and output are stopped for all channels in the
following cases:
When the [ SEL ] key is used in setting mode to change a setting,
pressing the [ ENT ] key enters the new setting.
A new setting will not be effective by simply changing a setting with the
[
SEL ] key in setting mode.
The entered setting is written to backup memory immediately before
CAN conversion and output.
In setting mode, CAN conversion and output are conducted when
setting item selection returns to the channel selection. Therefore, the
setting is written to backup memory at this time.
If 8910 power is turned off before setting item selection returns to the
channel selection, the setting change made in setting mode will not be
written to backup memory.
In CAL mode, pressing the [ SEL ] key changes the channel indication
in the forward direction. Pressing the [ SEL ] key while holding down the
[ ENT ] key changes the channel indication in the reverse direction.
In setting mode, pressing the [ SEL ] key changes the setting item
indication in the forward direction. Pressing the [ CAL ] key changes the
setting item indication in the reverse direction.