Steps
Note
●
Not all the application modes support violation detection.
●
The violation and incident detection types vary with different models. The actual device prevails.
1. Go to Configuration → Capture → Application Mode .
2. Select Application Mode.
3. Select the violation type(s) to be detected according to the actual needs.
Table 1-1 Violation Detection Types Description
Violation Detection
Type
Description
Seatbelt Unbuckled
The driver of a motor vehicle does not buckle the seatbelt during
driving. Check it and select the number of captured picture(s).
Phone Call
The driver of a motor vehicle uses the mobile phone to make or
receive calls during driving. Check it and select the number of captured
picture(s).
Checkpoint
Check it and select the number of captured picture(s).
Speeding
The motor vehicle is driven in the speed larger than the max. speed
limit of the lane. Check it and select the number of captured picture(s).
Driving on the Lane
Line
The motor vehicle is driven out of the lane and over the solid lane line.
Check it, select the number of captured picture(s), and set the
sensitivity.
Lane Change
Most part of the vehicle body crosses over the lane line and enters into
another lane. Check it and select the number of captured picture(s).
Manned Non-Motor
Vehicle
The non-motor vehicle carries a person illegally. Check it and select the
number of captured picture(s).
Wrong-Way Driving
The vehicle is driven in the direction opposite to the guidance direction
of the lane. Check it and select the number of captured picture(s).
Low Speed
The motor vehicle is driven in the speed lower than the min. speed
limit of the lane. Check it and select the number of captured picture(s).
Prohibition Violation
Left-turn violation, right-turn violation, emergency lane occupation,
large-sized vehicle passing violation, bus lane occupation, etc. Check it
and select the number of captured picture(s).
Network Traffic Camera Configuration Manual
21