HIKVISION IDS-2CD7A46G0-IZHSY 8-32, User Manual, Page: 33 / 90

Network Camera User Manual
UM Network Camera 072221NA 33
Steps
1. Go to
Configuration → Storage → Storage Management → Memory Card Detection
.
2. Click Status Detection to check the Remaining Lifespan and Health Status of your memory card.
•
Remaining Lifespan
: The percentage of the remaining lifespan. The lifespan of a memory card may
be influenced by factors such as its capacity and the bitrate. You need to change the memory card
if the remaining lifespan is not enough.
• Health Status : The condition of the memory card. There are three status descriptions: good, bad,
and damaged. You will receive a notification if the health status is anything other than good when
the Arming Schedule and Linkage Method are set.
NOTE: It is recommended that you change the memory card when the health status other
than “good.”
3. Click R/W Lock to set the reading and writing permission of the memory card.
•
Add a Lock
1) Set the
Lock Switch
to ON.
2) Enter the password.
3) Click
Save
• Unlock
­
If you use the memory card on the device that locked it, unlocking will be done automatically
and no unlocking procedures are required on the part of users.
­
If you use the memory card (with a lock) on a different device, you can go to
HDD Management
to unlock the memory card manually. Select the memory card, and click Unlock . Enter the
correct password to unlock it.
•
Remove the Lock
1) Set the Lock Switch to OFF.
2) Enter the password in
Password Settings
.
3) Click Save .
NOTE:
Only the admin user can set the
R/W Lock
.
The memory card can be read and written only when it is unlocked.
If the device that adds a lock to a memory card is restored to the factory settings,
you can go to
HDD Management
to unlock the memory card.
4. Set Arming Schedule and Linkage Method . See
Set Arming Schedule
and
Linkage Method Settings
for
details.