o
To leave a chase loop and go to the next valid scene, flash .
o
During a chase, only the number of the start-of-chase scene (SoC) is shown
in the display. The slider LED flashes slowly to indicate that a chase is
running.
o
If an End scene is encountered outside a chase loop, any sequence is
stopped after the current Fade or Hold time has expired.
Example of Using External Control
DMX data is lost and you activate external control. Power Cue Store invokes the
Loss of Data key; in this example, it outputs scene 00.
An example of using external control is shown below:
In the example, the following occurs:
o
DMX data is lost in A. The controller invokes the function you configured
for the Loss of Data key; in this case, it outputs scene 00.
o
In B, you set the binary address lines to the scene you want to output and
flash
STEP
. (Binary address lines are listed at the end of this manual.)
o
In C, a sequence runs from the start-of-chase scene (SoC) to the
end-of-chase scene (End). Then the sequence loops back to the
SoC
scene
and runs until you stop it. Unprogrammed or deleted scenes are ignored.
Power Cue Store
TM
User Manual
Page
13
