Configuring the Power Cue Store
TM
To enter configuration mode, the Power Cue Store must be receiving DMX data.
After verifying that DMX data is being sent, press the
CONFIG
switch using a thin
screwdriver or similar device. The display shows
CnF.
This mode allows you to adjust the following:
o
Global fade time
o
Global hold time
o
Loss of data key
Press
SCENE TYPE
at any time to toggle between the three options above.
Press
ESC
to exit configuration mode.
Global Fade Time
Press SCENE TYPE until
FAd
appears in the display, followed by the current
global fade time, in seconds.
The slider LED flashes to prompt you to input a value. Move the slider to adjust the
fade value between 0-0.9 seconds and 1-99 seconds, then press
STORE
.
The display then shows
YES
, then the new global fade time.
Global Hold Time
To set the global hold time, do one of the following:
o
Press
ESC
(which exits configuration mode)
o
Press
SCENE TYPE
until
Hld
appears in the display
The slider LED flashes to prompt you to input a value.
Move the slider to adjust the hold value between 0-0.9 seconds, 1-59 seconds and
1-30 minutes, then press
STORE
.
The display then shows
YES
, then the new global hold time.
To avoid confusion when setting fade and hold times, note the following:
00.1 = one tenth second.
01.0 = one second
1. = one minute
Loss of Data Key
The Loss of Data key setting determines what happens when DMX data is lost. To
set the Loss of Data key, do one of the following:
o
Press
ESC
(which exits configuration mode)
o
Press
SCENE TYPE
until
Lod
appears in the display
Choose one of the following four keys:
o
For stand-alone operation, select
Lod 3
. This holds the currently selected
scene. The display shows the scene number on loss of data.
Page
6
Power Cue Store
TM
User Manual
