Chapter 3 Configure the MarinePak7 Using the LCD UI
AUTO
The receiver searches for multiple L-band beams on the L-band channels based on AUTO
selection criteria.
If the receiver position is known, the AUTO selection criteria is a ranking of granted access
L-band beams by descending elevation angle.
If the receiver position is not known, the AUTO selection criteria is a ranking of granted access
L-band beams in the order they appear in the stored beam table.
MANUAL
The receiver is configured manually by selecting on the
Frequency
and
Baud
rate of the
beam..
Baud
Use this option to manually select the L-band data stream baud rate. This option is only available when
the tracking mode is set to
MANUAL
.
Press either the
Left
or
Right
buttons to select the baud rate option. See
Frequency
Use this option to manually select the L-band frequency. This option is only available when the tracking
mode is set to MANUAL.
Press the
Enter
button to enable frequency input. Use the
Left
or
Right
buttons to select the required
digit to change, then use the
Up
and
Down
buttons to change the value of the digit. When the user
frequency is displayed, press the
Enter
button to save to receiver.
The input range for Beam Frequency is 1525.0000 to 1559.9999. See
Satellite
Baud
Frequency
Location
AORW
1200 baud
1545.8450 MHz
54.00° west longitude
IOR
1200 baud
1545.8650 MHz
64.50° east longitude
25E
1200 baud
1545.8250 MHz
25.00° east longitude
143.5E
1200 baud
1545.8350 MHz
143.50° east longitude
98W
1200 baud
1545.8650 MHz
98.00° west longitude
Table 6: L-band Satellites
After the configuration options have been set, press the
Enter
button to accept the changes and save the
LBAND settings to the receiver.
Press the
Back
button to return to the LBAND Status screen or press the
Home
button to return to the
Position Status screen.
MarinePak7 User Manual 2
40
