Hettich 9 257 300, Operating And Assembly Instructions Manual

Page: 7 / 144

7
Space required for the machine
The space required by the drawer assembly jig is largely
governed by the dimensions of the machine frame.
Machine life
The machine's life will depend on whether or not it is used for its
intended purpose, on adherence to regular servicing intervals and
on the regular replacement of expendable parts.
2.4 Liability
Our liability is restricted to damage caused by improper use. We
shall not be liable for safety defects not yet identifiable on the
basis of the current state of the art.
Furthermore we are not liable for:
• violations against any safety advice for operating personnel
• violations against advice on particular hazards
• unauthorised modifications and alterations
• use of replacement and expendable parts or auxiliary materi-
als other than those approved by the manufacturer
Manipulation:
Manipulation of end position sensors inevitably leads to loss of
machine functionality. In particular, relocating the end position
sensors on the positioning cylinders must be viewed critically; for
this reason, these sensors are provided with a guard protecting
them from manipulation.
Note
The two hand pushbutton elements must be
checked and, if necessary, replaced after approx.
8 years (based on 255 working days of 16 hour
each, cycle 60s = 4080/ha).
i
2.3 Description of the machine
AvanFit YOU 400 is only used for automatically assembling Avan-
Tech YOU drawers.
All system related sizes can be processed between the largest and
smallest dimension!
The dimensions specified are key dimensions which can be set
using fixed stops.
Width is adjusted on the control panel.
Dimensions:
Length: 2,430 mm
Width: 1,180 mm
Height: 1,800 mm
Fig. 1: AvanFit YOU 400 drawer assembly jig
2. General
en