Hettich 9 257 300, Operating And Assembly Instructions Manual

Page: 30 / 144

30
8.2 Operating mode
The machine can be operated in various modes:
• Set up mode (key operated switch)
(Actuating the key operated switch provides the capability of
performing servo drive movements directly from the dis-
play. This operating mode must only be used by trained and
authorised persons)
• Two hand operating mode
(Production mode and selection of a new drawer width)
8.3 Switching machine ON
Turn on the main switch on the control cabinet
("I/ON" setting)
Fig. 19: Main switch – "I/OFF" setting
Note
These operating modes only work if all safety
guards are in effect!
i
8.1 Prerequisites for operating the machine
The following prerequisites must be met to operate the machine:
• No safeguards in place from servicing work
• Lubricate the guides if necessary.
• Undo all transport braces
• Check for leakages in the pneumatic system.
• Machine being supplied with compressed air
• Operating voltage connected
• There are no malfunctions (acknowledged)
Note
Setting up work must only be performed by
qualified staff (referred to below as "operator")
who, on the basis of their specialised training,
experience and instruction, possess sufficient
knowledge about:
• Safety rules
• Accident prevention regulations
• Fire regulations
Qualified staff must be authorised or entitled to
perform setting up work by the person respon-
sible for the machine.
i
Note
Follow the operating instructions posted by the
machine owner.
i
8. Operation
en