Hettich 9 257 300, Operating And Assembly Instructions Manual

Page: 32 / 144

32
en
Setting tolerance plates
• Move the tolerance plates to the required dimension points.
(25 and 27 mm size= 1 tolerance plate / 30 to 45 mm size =
2 tolerance plates / 48 to 60 mm size = 3 tolerance plates /
65 mm size = 4 tolerance plates)
Make sure that the threaded pins correctly engage.
Repeat process on opposite side.
Note
Please note that the positions of the tolerance
plates as well as the number of tolerance plates
must be matched to the depth of the drawer that
is being assembled.
i
To adjust the unit, turn the lever outwards by 90° and pull / push
the receiver element to the required position. Now turn the lever
back again and let it engage.
Receiver element in the TOP position for Inlay drawer side profile
with 16 mm base thickness.
Note
Make sure that the setting for the drawer side
profile contour is the same on both sides (left
and right).
i
8. Operation