4.
Slide the mounting bracket over the mounting rail on the slide assembly and secure it in position
with the white nylon thumbscrew.
5.
Manually pull the slide down to the fully extended position.
6.
Slide the valve into the mounting bracket and secure it using the black thumbscrews.
7.
Adjust the height and position of the mounting bracket to the approximate position desired. To
adjust the position, turn the handle on the clamp blocks counter clockwise, set the position and
secure by turning the handle clockwise.
Caution!
It is important to ensure that the dispense tip will not crash with the mounting
plate, fixture or part. Please ensure that the height is set to avoid crashes.
8.
Set the “POWER” switch to off (in the position marked “0”), the “DISPENSE PRESSURE” to
0 psi (turn the knob counter-clockwise until it stops) and the “VACUUM” off (turn the knob
clockwise until it stops).
9.
Reset the “EMERGENCY STOP” by rotating it in either direction and pulling it out.
Warning!
When the emergency stop is reset, the slide may retract. Be sure to keep
your hands and other objects clear of the slide before resetting the emergency stop.
10.
The single rotary dispense station is now ready to be programmed.
13
