6.2.6 Auto Repeat Mode
Overview
Auto Repeat Mode is used to continuously run a program with out any operator involvement (i.e.
pushing of the start button or the foot switch). To enter the auto repeat mode, you must first go to
auto mode then press the mode button for two seconds. When you release the mode button,
“Repeat” will be displayed to the right of “Auto” on the display as shown below.
Key Definition
MODE – to cycle between different modes. Pressing the button in auto repeat mode will bring
you to auto mode.
START – will start the program selected and will run it continuously without any operator input
until the stop button is pressed.
STOP – will stop the repetitive running of the selected program at the end of the next complete
program.
PURG - can be used to dispense adhesive at any time. This will typically be used during set up
to set the adhesive dispense rate or to purge the unit during extended down times when using
reactive adhesives.
23
