6.2.2 Changing Operating Modes
Auto Mode > Set Up Mode > Program Mode
The three modes that will be used the most frequently are auto mode, set up mode and
programming mode. Pressing the button indicated below will toggle through these modes in
that order.
Change Modes
Using This Button
Warning!
When exiting the setup mode, the slide may retract. Be sure to keep your hands
and other objects clear of the slide when changing modes.
Auto Repeat Mode
To enter the auto repeat mode, you must first go to auto mode then press the mode button for two
seconds. When you release the mode button, “Repeat” will be displayed to the right of “Auto”
on the display. When it is desired to return to other modes, you can exit the auto repeat mode by
pressing the mode button that will return you to the auto mode.
Global Parameters Mode
To enter the global parameters mode, you must first go to the program mode then press the mode
button for two seconds. When you release the mode button, “Gbl Mode” will be displayed above
the mode button. When it is desired to return to other modes, you can exit the global mode by
pressing the mode button that will return you to the auto mode.
Notice:
You can exit any mode at any time by pressing the mode button. If you are in the
program or global parameters mode, any changes that you have made will be saved when
returning to auto mode by quickly pressing the mode button.
19
