EPS 45-80 High-Voltage Generator
5-4
Technical Manual P/N 9894.00.G6
5.1.1.2
EPS Starter board P/N 11104.xxx
1.
Make sure that the EPS Starter Board model fitted on your generator matches your tube rotor
type (Figure 5.1(b)).
EPS Starter board P/N 11104.001 : Low Speed Starter (most common stator types)
EPS Starter board P/N 11104.002 : High Speed Starter (most common stator types)
EPS Starter board P/N 11104.003 : Low Speed Starter, Low Impedance (Q & E Stators)
EPS Starter board P/N 11104.004 : High Speed Starter, Low Impedance (Q & E Stators)
Figure 5.1(b) –
Anode Starter
board P/N 11104.xxx.
2.
Make sure that the configuration of the EPS Starter Board installed with your generator is
appropriate for your tube rotor type. Refer to the Configuration Tables 51 & 52 to adjust, if
necessary, the configuration of the stator type using SW1 dipswitch and the jumper cables (10)
provided with the board. This step requires that the board is first taken out of the generator
upper basket.
Table 51-
EPS Starter Board Configuration - II-
Stator Types
SW1-1
SW1-2
SW1-3
SW1-4
“R”
Off (0)
Off (0)
Off (0)
Off (0)
“S”
Off (0)
Off (0)
Off (0)
On (1)
“XS-R”
Off (0)
Off (0)
On (1)
Off (0)
“TS1”
Off (0)
On (1)
On (1)
Off (0)
“DT1”
Off (0)
Off (0)
On (1)
On (1)
“IAE”
Off (0)
On (1)
On (1)
On (1)
“Q”
Off (0)
On (1)
Off (0)
On (1)
“E”
Off (0)
On (1)
Off (0)
Off (0)
