Heatmor 200 SSP, User Manual

Page: 75 / 80

70
Faulty electrical supply.
Check electrical
connections.
Contact your
electrician.
Indoor forced air furnace
fan is full of dirt or filter
is plugged and therefore
the air flow is reduced
going through the coil.
Contact your
Local Dealer.
Improper installation of
coil in forced air furnace.
Contact your
Local Dealer.
Too small a coil in forced
air furnace.
Auger Speed too low Increase Auger Speed
refer to “Dayton auger speed
control”
Inadequate Baseboard.
When a water-to-water
heat exchanger is
installed, a temp drop
of 20-30° across heat
exchanger may be
experienced.
Contact your
Local Dealer.
not enough
domestic hot
water.
Hot water heater
is too small.
Sidearm exchanger
needs to have a pump
installed.
Refer to
“installation Manual.”
Somewhere in the
domestic water system
of the house, the hot and
the cold can mix, (as in a
single faucet outlet) and
the resulting mixed warm
water is being sent to the
hotwater taps instead of
pure hotwater
Contact your
Local Dealer .
PrOBLeM cause sOLutiOn PrOceDure