Heatmor 200 SSP, User Manual, Page: 68 / 80

63
Furnace will not
burn properly
or will not
maintain water
temperature.
Chimney plugged. Clean Chimney.
Refer to
“chimney stub.”
Not enough wood pellets
in hopper.
Add wood pellets.
Refer to
“Loading wood pellets into the
heatMOr™.”
Poor quality wood pellets. Better wood pellets.
Refer to
“What can i Burn”
Draft flipper stuck.
Remove blower and
flipper assembly-clean,
lube or replace.
Refer to
“steps to Maintain your
Blower and Flipper assembly.”
Electrical power is off or
not constant.
Check all electrical
connections. Call
dealer or licensed
electrician.
Refer to
“electrical (contact Local
Dealer).”
Fire is out.
Re-light fire.
Refer to
“Lighting Your heatMOr™.”
Flue plugged. Clean Flue.
Refer to
“Flue.”
Blower fins are full of
dust.
Clean Blowers.
Refer to
“steps to Maintain your
Blower and Flipper assembly.”
Blowers not running
properly or up to speed.
Clean Blowers.
Refer to
“steps to Maintain your
Blower and Flipper assembly.”
Ashes in Air Box(s). Clean Air Box(s).
Refer to
air Box(s).
Too many ashes in
Firebox restricting air
flow.
Clean out ashes.
Refer to
“ash Management and ash
removal.”
Auger Speed too low Increase Auger Speed
refer to “Dayton auger speed
control”
PrOBLeM cause sOLutiOn PrOceDure