26
Heat & Glo •
PHFR-PRIMO-48, PHFR-PRIMO-60, PHSI-PRIMO
Instructions • 2560-970 Rev. D • 2/19
5. Locate the Open Top Discharge bend lines on the
nailing tabs of the discharge assemblies. See Figure
8.8.
6. Bend or cut the nailing tabs at this location to break
off excess nailing tab material not needed for Open
Top Discharge. See Figure 8.9.
Figure 8.8 Bend/Cut Line Locations - Shown Unpainted
Note:
For See-Through models, it is required to cut the
mounting brackets using a snip to a shorter length. Leave
as much overlap as possible for maximum support. See
Figure 8.7.
Figure 8.7 Shorten Bracket for See-Through Models
BEND/CUT LINES
Figure 8.9 Cutting the Nailing Tabs
7. Bend over both register cover tabs as shown in Fig-
ure 8.10 and 8.11.
Figure 8.10 Bend Register Cover Tabs
Figure 8.11 Register Cover Tabs Bent
REGISTER COVER TABS
BEND LINE
