9
Heat & Glo •
PHFR-PRIMO-48, PHFR-PRIMO-60, PHSI-PRIMO
Instructions • 2560-970 Rev. D • 2/19
Figure 5.3 Remove Bottom Panel
WARNING! Choking Hazard!
Keep media and stones
out of reach of children.
6. Remove transition media tray.
7. Remove LED Tray assembly
8. Remove glass mounting brackets, if installed. See
Figure 5.2.
9. Remove bottom panel to access component tray as
shown in Figure 5.3.
10. Disconnect the two wires attached to the limit switch.
See Figure 5.4.
5. Remove media from the front media tray. Remove
refractory pieces, if installed.
Figure 5.2 Remove Existing Glass Mounting Brackets (If Installed)
1. Press glass suction cups firmly against glass to create
a solid hold.
2. Slide glass straight up behind finishing material. See
Figure 5.1, Detail A.
3. Tilt bottom out as shown in Figure 5.1, Detail B. Slide
glass down to remove it from the appliance.
4. Set glass on prepared work surface.
Figure 5.1 Barrier Glass - Clean Face Finish
UP
TILT OUT
THIS SIDE OUT
THIS SIDE OUT
DETAIL A
DETAIL B
Barrier Glass Weights
PRIMO48
PRIMO60
12 lbs
14 lbs
WARNING! Risk of Injury! Glass is heavy.
• Glass assembly installation and removal must be
performed by a qualified service technician. See Table
5.1 below for glass assembly weights.
• Use suction cups to handle glass.
• PRIMO60 Models: It is recommended that Glass
installation and removal be performed by two qualified
service technicians.
• Wear protective gloves and safety glasses during removal
and installation.
5. Remove Barrier Glass/Bypass Limit
Switch and Glass Mounting Brackets
Note:
For See-Through appliances remove only the
glass on the control cavity side of the appliance.
Table 5.1