HDMI Sirius-PJ2, Field Service Manual

Page: 25 / 172

2. Installation
Installation Requirements
• Do not cover the lens with the lens cap or equivalent while the projector is on. Doing so can lead to
melting of the cap due to the heat emitted from the light output.
• Do not place any objects which are easily affected by heat in front of the projector lens. Doing so
could lead to the object melting from the heat that is emitted from the light output.
Do not use the projector with it leaning to the left or right. This may result in a malfunction. However,
portrait installation is possible* (when a custom-designed stand is made). For portrait installation, install
the projector with the intake vent at the bottom and leave a space of at least 130 mm below the intake
vent.
Fire and Shock Precautions
• Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the build-up of
heat inside the projector. Allow at least 4 inches (10cm) of space between the projector and a
wall.
• Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become
heated while the projector is turned on and immediately after the projector is turned off. Parts of the
projector may become temporarily heated if the projector is turned off with the Power button or if
the AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
• Prevent foreign objects such as paper clips and bits of paper from falling into the projector. Do not
attempt to retrieve any objects that might fall into the projector. Do not insert any metal objects such
as a wire or screwdriver into the projector. If something should fall into the projector, disconnect it
immediately and have the object removed by qualified service personnel.
• Do not place any objects on top of the projector.
• Do not touch the power plug during a thunderstorm. Doing so can cause electrical shock or fire.
23