HDMI Sirius-PJ2, Field Service Manual

Page: 106 / 172

When the adjustment described below, from the procedure "Replacement of the PCB Main Ass’y",
"Replacement of the OPT BASE" and "Miscellaneous" is done, click [Adjust End] button.
* When adjustments of another set are further intended, operation should be started with [Adjust Start].
* If trying to adjust another set without making [Adjust End], there will be an error as a result of model
discrimination.
* Click [Close] button to terminate the program.
Replacement of the PCB Main Ass’y
Copy all data when replacing the PCB Main Ass’y.
*If All Data Copy is impossible to carry out, refer to "Miscellany (Failure in <All Data Copy> to be
performed at the time of PCB Main Ass’y replacement)."
In regard to the replacement of servicing parts for the PCB Main Ass’y, the procedures described below
should be followed.
• Before the replacement of PCB Main Ass’y
1. Copying of all data
• After the replacement of PCB Main Ass’y
1. Data writing for each model is carried out.
2. EDID data writing is carried out.
3. Data writing for Serial number and Model number
All Data copying
All Data mentioned here denote the respective factory adjusting data (Flicker, VT, Uniformity, Color
Correction, Multi), and Usage Time.
3. Replacement and Adjustment
104