Hawking HomeRemote HRNC1, User Manual

Page: 10 / 73

10
4.3 Installation Procedure
1. Unpack all of the contents from the network camera’s package and verify that all the items listed in the “Package
Contents” chapter have been included.
2.
Locate the antenna connector on the left side of the camera’s rear panel. Screw the base of
the antenna (included with the HRNC1) into the antenna connector.
3.
Locate the network cable connector (LAN port) on the camera’s rear panel. Connect an
Ethernet cable to the port. Connect the other end of the cable to the network.
Please Note :
For initial setup and configuration, you will need to use a wired connection. After
completing the setup and configuration, you can begin using your network camera
wirelessly.
4. Locate the power input connector on the camera’s rear panel, and attach the external power
supply. Then, plug the adapter into an available outlet. Please check to see that the orange
“Power” LED located next to the lens of the camera (front side) is lit to ensure that the
camera is powered on. (To ensure a network connection, please check to see that
the green “Link” LED is lit or flashing.)
Please Note
: It is strongly recommended that you use the power adapter that was shipped with the network camera. Do
NOT use power adapters from any other source.
2
3
4