Propeller Owner's Manual
136
INSTALLATION AND REMOVAL
61-00-36
Page 3-64
Rev. 2 Feb/17
11. Propeller Removal
A. Removal of “R” Flange Propellers
(1) Remove the spinner dome in accordance with the
Spinner Removal procedures in this chapter.
(2) If the propeller is equipped with an ice protection system
that uses components supplied by Hartzell Propeller
Inc., applicable instructions and technical information for
the components supplied by Hartzell Propeller Inc. can
be found in the following publications available on the
Hartzell Propeller Inc. website at www.hartzellprop.com:
(a) Hartzell Propeller Inc. Manual 180 (30-61-80) -
Propeller Ice Protection System Manual
(b) Hartzell Propeller Inc. Manual 181 (30-60-81) -
Propeller Ice Protection System Component
Maintenance Manual
(c) Hartzell Propeller Inc. Manual 182 (61-12-82) -
Propeller Electrical De-Ice Boot Removal and
Installation Manual
(d) Hartzell Propeller Inc. Manual 183 (61-12-83) -
Propeller Anti-Icing Boot Removal and Installation
Manual
(3) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder’s Instructions for Continued
Airworthiness (ICA).
(4) If installed, cut and remove the safety wire or safety
cable on the propeller mounting stud nuts.
WARNING:
MAKE SURE THE SLING IS RATED UP
TO 800 LBS. (363 KG) TO SUPPORT THE
WEIGHT OF THE PROPELLER ASSEMBLY
DURING REMOVAL.
(5) Support the propeller assembly with a sling.
