3-1 Receiving Inspection
86
1
2
3
4
5
6
7
8
9
10
11
付
Ins
ta
lli
ng t
he
S
H
A
a
c
tua
tor
3-1
Receiving Inspection
Check the following items after unpacking the package.
Inspection procedure
1
Check the items thoroughly for damage sustained during transportation.
If any item is damaged, immediately contact the dealer.
2
Confirm the actuator is what you ordered.
The nameplate is found on the rear end face of the SHA series actuator. Check the TYPE field
on the nameplate to confirm that it is indeed the model you have ordered. If any item is wrong,
immediately contact the dealer.
Refer to the section 1-2 in this manual for the detail of the model codes.
3
Check driver input voltages.
The driver's model code is shown in the TYPE field of the driver's nameplate. The last three
digits of this model code indicate the input voltage to be input.
100: indicates a single phase 100VAC power supply.
200: indicates a 3-phase/single-phase 200VAC power supply.
If the voltage to be supplied is different from the label voltage, immediately contact the dealer it
was purchased from.
Do not connect a supply voltage other than the voltage specified
on the driver label.
The wrong power supply voltage may damage the driver, resulting in physical
injury or fire.
WARNING
