12
Martin
®
ERA 150 Wash User Guide
Physical installation
Warning! Read
3 before
installing the fixture.
The fixture is designed for indoor use only and must be used
in a dry location with adequate ventilation. Ensure that none of
the fixture’s ventilation slots
are blocked.
Fasten the fixture to a secure structure or surface. Do not
stand it on a surface or leave it where it can be moved or fall
over. If you install the fixture in a location where it may cause
injury or damage if it falls, secure it as directed in this user
manual using a securely anchored safety cable that will hold
the fixture if the primary fastening method fails.
Martin can supply safety cables and rigging clamps that are suitable for use
with the fixture (see
on page 49).
Fastening the fixture to a flat surface
The fixture can be fastened to a hard, fixed, flat surface. Ensure that the
surface and all fasteners used can support at least 10 times the weight of all
fixtures and equipment they will support.
Fasten the fixture securely. Do not stand it on a surface or leave it where it
can be moved or fall over. If you install the fixture in a location where it may
cause injury or damage if it falls, secure it as directed below with a securely
anchored safety cable that will hold the fixture if the primary fastening
method fails.
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging
structure in any orientation. You must use a half-coupler
clamp (see illustration on right) that completely encircles the
truss chord.
To clamp the fixture to a truss:
1. Check that the rigging structure can support at least 10 times the weight
of all fixtures and equipment to be installed on it.
2. Block access under the work area.
Summary of Contents for Martin ERA 150 Wash
Page 1: ...ERA 150 Wash User Guide ...
Page 46: ...46 Martin ERA 150 Wash User Guide Dimensions All dimensions are in millimeters ...
Page 51: ......
Page 52: ...www martin com ...
