Hardi SARITOR 4000, Operator'S Manual

Page: 37 / 94

35
Starting the SARITOR
General information
±
WARNING! Before starting the engine, check the level of the engine oil, coolant and hydraulic oil. Check that the
engine radiator and air filter is clean.
Powering the electrical system
The SARITOR is equipped with a battery cut-off switch located near the access ladder to the cab.
• Turn the handle of the battery cut-off switch clockwise (vertical
position) to power the electrical circuits of the SARITOR.
÷
Note: Turn the handle of the battery cut-off switch counter-
clockwise (horizontal position) to disconnect power to the
SARITOR.
±
WARNING! Never leave a battery charger connected to the SARITOR at high amp (boost) setting. Damage to the
electronics may occur. To jump start the SARITOR, only use a charger for as long as necessary to start the engine.
±
WARNING! Either remove the battery or turn the battery cut-off switch to “OFF” before charging the battery to avoid
damaging the SARITOR electronics. See “Charging the Optima AGM battery” on page 72.
Lighting the path to the cab
The self-propelled SARITOR is equipped with lights for the ladder and
work platform to assist in climbing up to the cab during low light
conditions.
Press button (1) to turn on the headlights (2) and (3).
The headlights will automatically shut off after a few minutes.
˜
ATTENTION! The battery cut-off switch must be in the “ON” (vertical) position in order to power the lights.
÷
Note: Button (1) will be illuminated with an LED when the power is “ON”.
3
2
1
5 - Operation