Hardi SARITOR 4000, Operator'S Manual

Page: 33 / 94

31
General information
Unloading the sprayer from the truck
The machine can only be unloaded if the engine is running. In effect, the braking system is engaged unless the engine is
running. To move the self-propelled, you must observe the following points:
Turn the battery cut-off handle to power the electrical circuits.
Place the forward handle in neutral.
Check that the parking brake is engaged.
Turn the ignition key to start the engine.
Press the engine throttle switch to increase engine rpm. To ensure sufficient traction and braking of the self-propelled on an
incline, the engine rpm must be a minimum of 1500 rpm.
Push the Grip handle forward very slowly to move forward or back to move backwards.
Ensure that no one is in the unloading area.
Do not attempt to unload the sprayer if you are unfamiliar with the instructions described above.
Access to the engine
To access the engine, you must lift the hood. For more information on periodic maintenance of the engine, see chapter
“Service and Maintenance intervals” on page 64.
Opening the hood
• Turn valve handle to position (1).
• Use the manual pump to lift and hold the hood open to the
desired height.
Closing the hood
• Gradually turn valve handle to position (0) to close the hood.
÷
Note: The valve handle should remain in position (0) after the
hood is lowered.
Check engine
The main elements must be verified before the first starting of the engine:
• Coolant Level and Engine Oil Level
• Correct tightness of the oil and fuel filters
• Tension on the belts
1
0
4 - Sprayer setup