Four post workshop lift HAPP27
Version 5
WWW.HAPP.COM.AU
7
personnel over 18 years only. Always keep the lift and lift area clean and free of tools, parts,
debris etc. Once the template contact the lift points, check template for engagement. After raising
the vehicle briefly, stop and check the template for secure contact. Always make sure the vehicle
doors are closed during raising and lowering cycles. Closely watch the vehicle and the lift during
raising and lowering cycles.
Do not
allow anyone to stay in lift area during raising and lowering cycles.
Do not
allow anyone on lift or inside raised vehicle. Only use the lift for its intended purpose.
Comply with the applicable accident prevention regulations.
Do not
overload the lift. the rated load capacity is indicated on the lift nameplate.
Only use the vehicle manufacturer’s recommended lift points.
After positioning the vehicle apply the parking brake.
Use caution when removing or installing heavy components (center – of – gravity displacement).
Protect all parts of the electrical equipment from humidity and moisture.
These documents shall not relieve the owner/operator of its legal responsibilities or obligation in
accordance to the Workplace Health and Safety Act 2011.
Servicing overview
l
Maintenance or repair work by authorized service personnel only.
l
Turn off and padlock the main switch before doing any maintenance, or repair work
Work on electrical parts by authorized service personnel only.
l
Work on the electrical equipment by certified electricians only.
l
Ensure that ecologically harmful substances are disposed of only in accordance with the
appropriate regulations.
l
Do not use high pressure/steam jet cleaners or caustic cleaning agents. Risk of damage!
l
Do not replace or override the safety devices.
l
The MSDS of the hydraulic oil shall be obtained and kept at the easily accessible place for
reference in the emergency situation.
Workplace Health and Safety (WH&S) Design
registration and operation
This hoist is able to be operated in workplaces within Australia and New Zealand AFTER REGISTRATION
by HAPP. Operation of a hoist in accordance with WH&S is the responsibility of the owner and operator.
HAPP believe this starts with the installation of the design registered hoist and is dependent on regular training
of operators and regular maintenance by the workshop. These procedures are to be documented by the owner
and operators of the hoist. HAPP provide documents of the hoist as part of a WH&S pack which includes the
formal design registration documents and documents that can be used to record the operation and
maintenance of the hoist. These documents are important as a base for documenting the regular training and
