![background image](http://html1.mh-extra.com/html/happ/27/27_installation-and-operation-manual_3753538016.webp)
Four post workshop lift HAPP27
Version 5
WWW.HAPP.COM.AU
15
Figure: picture of parts supplied with 4 post lift
The parts are listed below.
Number
Description
1
Covers for cross beam
2
End plates connected to front of runway
3
Guide pins that fit into column end of cross beams
4
Guide plates that fit underneath slave runway (no cables), to
prevent runway from lifting from cross beam
5
Mounting bar for end plates (2)
6
Wheel chocks, need rubber pads on hoist (not supplied) to work
effectively. (HAPP 28 only)
7
Nuts and bolts package
8
Tru bolt package, 18mm bolts.
9
Hose connection from pump control unit to cylinder in main
runway.
10
Filler plate for runway, A smaller filler plate (1/3 the size) is also
packed but not shown in this picture. (HAPP 28 only)
Removing the runways
The top runway is upside down, it can be turned over during removal, prior removal
the
hydraulic ram should be extended to its full length, this will make installing of the
cables easier later on, be aware the oil will come out of cylinder as the cables are
pulled.