36
Step 17
After the CA has been allowed to cure, lightly pull on
the elevators and stabilizer to make sure the hinges are
glued securely.
Step 18
Flex the elevators up and down a few times to break in the
hinges and reduce the load on the servos.
Step 19
Fit the fin into the fuselage and check that it is square to
the stabilizer. Lightly sand the fuselage to correct for any
alignment problems.
Step 20
Installing the fin follows the steps similar to installing the
stabilizer. You will need to follow Steps 5 and 6 to remove
the covering from the bottom of the fin where it contacts
the fuselage. Use 30-minute epoxy when gluing the fin to
the fuselage.
Section 8: Tail Installation
Summary of Contents for Sundowner 50 ARF
Page 45: ...45 Building and Flying Notes ...
