24
Step 9
Secure the throttle pushrod in the brass connector using
a 3mm x 4mm machine screw. Cut the pushrod wire so
it extends only 1/8-inch (3mm) beyond the connector
to prevent interference between the linkage and the tail
servos. Use threadlock on the screw to prevent it from
vibrating loose.
Step 10
Slide the pushrod standoff so it can be glued to the side
of the fuselage using medium CA as shown.
Step 6
Enlarge the outer hole in the throttle servo horn using a
5/64-inch (2mm) drill bit and pin drill. Slide the brass
connector into the hole as shown.
Step 7
Secure the connector to the servo horn using the
connector backplate.
Step 8
With the radio system on, center the throttle stick and
trim. Install the servo horn on the servo as shown.
Section 4: Throttle Servo Installation
Summary of Contents for Sundowner 50 ARF
Page 45: ...45 Building and Flying Notes ...
