41
o
Step 6
Use a pair of pliers to make a 90-degree bend in the
pushrod at the mark made in the previous step.
o
Step 7
Use a pin drill and a 5/64-inch (2mm) drill bit to enlarge
the outer hole in the servo arm.
o
Step 8
Slide the pushrod wire through the hole in the servo horn.
Slide the snap link onto the pushrod wire, then rotate it
until it snaps on the wire.
o
Step 9
Use side cutters to remove the excess wire. Leave at least
1/16-inch (1.5mm) exposed beyond the connector to
prevent the wire from coming out of the connector.
Section 10: Radio and Pilot Installation
Summary of Contents for Sundowner 50 ARF
Page 45: ...45 Building and Flying Notes ...
