35
o
Step 13
Slide the elevator onto the joiner wire. Note the location of
the elevator control horn.
o
Step 14
Check the fit of the hinges from the elevator into the slots
in the stabilizer. The elevator will fit tightly against the
stabilizer when installed.
Step 15
Repeat Steps 13 and 14 to check the fit of the remaining
elevator. Use 30-minute epoxy on the joiner wire and
elevators to glue them together.
Step 16
Wick thin CA into each of the six hinges on both the
top and bottom of the stabilizer. Do not use accelerator
on the hinges, as this will not allow the CA to fully wick
into the hinges.
Section 8: Tail Installation
Summary of Contents for Sundowner 50 ARF
Page 45: ...45 Building and Flying Notes ...
