HandTop HT3200-UV K Series, Installation Instruction

Page: 32 / 113

31
2. Button function introduction:
AUTO: (Smart mode) Entry method: Press once to enter the mode, press AUTO k ey
( D1 ) again to display the room temperature, and automatically return to the
display water temperature after 3 seconds.
CONSTANT (constant temperature mode) Entry method: same as smart mode
entry method and function
SET (Settings): Entry method: Press SET key to enter the setting state, can adjust all
the default parameters from C0 to C8, no operation button for more than 10
seconds or press SET button to exit the setting and save the parameters.
- + (minus and plus key): All parameters are modified by the plus or minus key.
(Up and down keys): Press the up and down keys to switch from C0 to C8
when entering the SET state; press the up and down keys to adjust the UV lamp
power without entering the SET state (whether it is adjustable according to the
actual situation of the UV manufacturer)
QA : phase A loss QB : phase B loss QC : phase C loss QF : phase sequence error OK :
three phase normal
Press and hold the SET button for 4 seconds to reset all set values to the initial
state.
3.Control mode selection and working mode details
CONSTANT (Constant temperature mode): (factory default: 26
℃
)
D2 displays the current set temperature value, directly press the plus or minus
button to change the set value, real-time water temperature (D1) = set temperature
(D2)
±
return difference value(C1). The setting range is 5
℃
- 40
℃
, the default
is 30
℃
. In addition, the set temperature value cannot exceed the
upper limit (C5), Lower limit (C4) temperature range.