Hammerhead HG2200AT, Operator'S Manual

Page: 96 / 146

HG2200/HG2200AT Operator’s Manual
Electric Strike System (ESID)
Systems and Equipment - 95
Test Strike System
If system fails any part of this test, see “Troubleshoot Strike System” on the following page. Do not winch
until test is completed successfully.
1. Turn on unit. “Start Unit” on page 64
2. ESID control module will perform internal tests which check everything but alarms and strobe.
3. If green OK indicator and electrical power supply indicator lights remain on, press self test button to
perform total test of strike system. During this test:
•
All lights should glow.
• Alphanumeric readout should display numbers.
• Alarms and strobes on all connected units should sound.
4. If this test is successful, OK indicator and electrical power supply indicator lights will remain on.
5. Use Electric Strike Simulator to test voltage and current sensors. See page 99.
ESID Diagnostic Codes
When strike system detects a problem, an error code will be displayed. Anytime this happens, press self-
test button to retest. If error code is still displayed and does not appear in this chart, have control module
checked or replaced.
Code Display Condition Result
502 2.5V REF 2.5V reference error in ESID Internal reference failure, ESID may
not give valid readings
503 -5V REF -5V reference error in ESID internal reference failure, ESID may
not give valid readings
504 CLK RESP clock response error clock my not be working
505 LCD RESP LCD response error LCD display my not work
506 LED RESP LED response error LED display my not work
507 LCD CONTR LCD contrast error LCD contrast not saved properly
508 COP RESET cop watchdog error processor has reset, unknown status
of ESID code
510 STRB DVR strobe driver output error strobe may not function
511 HORN DVR horn driver output error horn may not function
512 BAT POWER battery power/horn driver error strike hold on power may not
function
513 TEST WIRE no continuity on test wire for
testing ESID
information center may not be able
to reset ESID
515 STR VOLT strike voltage input error