18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 4
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
System Installation
Prerequisites
A. Prepare the car:
Before fitting the System Panel in the car,
1.
The Luggage Compartment Pan (A) (part no. 51476981061) and the Battery Cover (B) (part
no. 51476981050) will have to be removed to make room for the installation.
2.
The X6 Interior-Rear-Storage Compartment Right (C) (part no. 51476981048) sits right
underneath the Right Flap (D). An 8cm hole will need to be opened on the front side of this
Storage Compartment, large enough for the connecting Powerpole plugs to pass through it.
B. Prepare the PM panel (see The Power Management Area):
The Power Management Panel houses 3 components from CTEK and a Grounding Bus Bar (GBB).
CTEK M300 charger #1.
CTEK Smartpass #2.
CTEK D250S Dual #3.
Grounding Bus Bar #8 (GBB).
1.
Attach all the PM components (D250S, Smartpass, M300 and Grounding Bus Bar).
2.
Now connect all cables to each PM component (LOOM1 & LOOM2) (see Appendix A).
D. Prepare the SP by making sure:
1.
All 3 base brackets are attached and
2.
Both side brackets are not attached so as not to interfere with the installation (we will add
them later on).
3.
The 2 bottom Inverter screws are screwed onto the SP to allow easy Inverter fastening.
4.
Attach the PM panel to the SP and
5.
Take the SP & the 3 other panels to the car for installation (see Installation procedure).
CAUTION: Please arrange for adequate protection of your rear bumper during installation to protect
it from scratches.
