18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 16
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
Installation:
Where to install:
The power inverter should be installed in a location that meets the following requirements:
Dry – Do not allow water to drip or splash on the inverter.
Cool – Ambient air temperature should be between 0 and 40 , the cooler the better.
Safe – Do not install in a battery compartment or other areas where flammable fumes may
exist, such as fuel storage areas or engine compartments.
Ventilated – Allow at least one inch of clearance around the inverter for air flow. Ensure the
ventilation openings on the rear and front of the unit are not obstructed.
Dust – Do not install the Inverter in a dusty environments where are dust, wood particles or
other filings/shavings are present. This dust can be pulled into the unit when the cooling fan
is operating.
Avoid excessive cable lengths but do not install the Inverter in the same compartment as
batteries.
Use the recommended wire lengths and sizes (see section 3-5). Also do not mount the
Inverter where it will be exposed to the gases produced by the battery. These gases are very
corrosive and prolonged exposure also will damage the Inverter.
DC Input Terminals
Model
DC Input Voltage
12 V
Minimum
Maximum
10.5
15
WARNING!
Connect to 12V battery ONLY! (+) is positive, (-) is negative.
WARNING!
Reverse polarity connection will blow internal fuse and may damage inverter permanently.
WARNING! Shock Hazard.
Before proceeding further, carefully check that the Inverter is NOT connected to any
batteries, and that all wiring is disconnected from any electrical sources. Do not connect
the output terminals of the Inverter to an incoming AC source.
The X6-Electrmod bests the manufacturer recommendations for wiring and our
solution provides a 200A CB in place of the 200A fuse recommended.