18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 12
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
Thermal Sensors
The M300, Smartpass and D250S each come with a thermal sensor cable (#10) attached to the
device. These should be attached on the top surface of one of the batteries in the Service Battery
Bank, preferably near the positive pole.
2. The Service Battery Bank Compartment
The area houses the Service Battery Bank.
If choosing your own batteries, please make sure the model you choose will be smaller than the
space specified below. Between 1 or 2 large capacity batteries can fit in this space, depending on
their dimensions and protrusions.
WARNING!
Both batteries must fit in this space:
Length 11.13in (283mm) x Width 13.2in (336mm) x
Height 9.25in (235mm).
Not even a millimetre larger! You may have to remove the battery
holding straps after inserting the batteries into the Service Battery Bank compartment.
Store these in a safe place for when you will need to replace the batteries or in case you
may need to service the system.
Battery Fastening
On the left side of the Service Battery Bank, we have the main Alternator Battery and on the right
side, the Power Distribution Vertical Panel holding the batteries from moving in either direction. If
required, a battery fastener can be used to hold the batteries down onto the trunk floor. In our case
we found that this is not necessary.
