18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 21
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
Installation procedure
Installation comprises of 10 sections. Follow the instructions closely for each section in sequence.
A.
System Panel (SP)
B.
Inverter
C.
Cable Harness
D.
Chassis GND
E.
Power Distribution Vertical Panel
F.
Power Distribution Bottom Panel
G.
Power Distribution Top Panel & CBs
H.
The Batteries
I.
System Control Panel (SCP)
A. System Panel (SP)
1.
With the help of the SP rear handles, lower the SP carefully into the trunk compartment.
Please note: Slide all 3 Inverter cables (Green color coded - INV/P-CB7, INV/N-SBB/N,
INV/GND-BB) past the right hand side of the SP before securing it.
2.
The base brackets of the SP will help it to stand upright. These should line up perfectly with
ridges found on the floor of the trunk compartment. Carefully move the SP towards you until
these brackets can be inserted into these floor ridges, thus holding it in place.
CAUTION: Do not place too much force or you can break the brackets off the panel. Once the
brackets are aligned and level, they should easily be pushed into the ridges by slightly
tapping on the lower middle part of the SP with your palm.
Please note: Before you proceed, make sure your trunk floor door can be closed properly. If
you find that the trunk floor door needs a lot of effort to close properly, then you need to
recheck your installation for problems. If you have followed closely the above steps, there
should be no problems closing the floor door.
3.
Screw the side brackets onto the SP. Then drill 2 holes on each side of the trunk
compartment and screw the brackets into position. The SP is now secured.
B. Inverter
1.
Take your inverter and lower it behind the SP without fastening it. Now take each Inverter
cable and secure it in its proper place on the Inverter.
Please note: You may want to place the Inverter on a soft rug to avoid scratching it on the
trunk floor.
2.
Now, secure the Inverter on the back of the SP.
3.
Attach the Inverter power output cable and the remote cable to the Inverter.
4.
Remove the Interior-Rear-Storage Compartment Right (C).
5.
Pass the Inverter’s power cable and remote cable past the right side of the SP and into the
area where the Interior-Rear-Storage Compartment Right (C) used to sit. Leave them loose
there for now.
