HAKO 147015, Operating Manual

Page: 62 / 190

62
02-147015-00-00.fm
Use
2.3.5 Arm rest control panel
Hako button
The Hako button Fig. 50-71 switches from transport mode to work
mode or vice versa and starts automated procedures according to the
attachment.
The accelerator pedals must be in the neutral position.
In the multifunction display, the transport mode
Fig. 50-A , or front tool car-
rier symbol Fig. 50-B appears.
The vehicle speed in the:
•
transport mode is 0 to 25 km/h,
•
work mode 15/20/25 km/h according to selected engine speed.
You will find the functional description of the Hako button for attachments
in chapter 6.
Joystick
The front tools are operated with the joystick Fig. 50-70 . The joystick acts
on the front tool carrier Fig. 50-12 and on the hydraulic connections
Fig. 50-F .
The following functions are possible:
•
Joystick forwards: Lowering front tool carrier (floating position)
•
Joystick back: Raising front tool carrier
•
Joystick to the left: The front tool swivels to the left
•
Joystick to the right: The front tool swivels to the right
In the multifunction display, the upper stop information symbol Fig. 50-C
or floating position symbol Fig. 50-D appears.
The function of the joystick with an attachment is described in chapter 6.
Using the button
Fig. 50-E in the joystick it is possible to control an addi-
tional hydraulic component via a changeover valve (e.g. wedge snow-
plough). To do so, the changeover valve of the attachment must be
connected to the 19-pin X63 socket, see page 76. The additional function
is active if the button is pressed and the joystick simultaneously moved.
Turn-push knob
The turn-push knob Fig. 50-69 is located in the right armrest of the driver's
seat. Menus and submenus are selected in the multifunction display and
the individual menu item values are set or changed with the turn-push
knob, see page 35.
Fig. 50:
70
71
69
C D B
E
A
F
12
Note
•
For reasons of safety, lowering the front tool carrier with the
vehicle moving is possible only in the work mode. In the
transport mode, the front tool carrier can be lowered only if
the accelerator pedals are in neutral position.
•
If the front tool does not have to be lowered completely,
interrupt the lowering movement by briefly pulling the
joystick back.
•
If the movement of the front tool does not agree with the
movement of the joystick, change over the hydraulic
connections.