05-147015-00-00.fm
113
Maintenance and Servicing
5.9 Wheels
5.9.1
Tyre changing
Dismantling
1. Place the vehicle on a level surface and hold it with the parking brake.
Switch the engine off and pull out the ignition key. Let the engine cool
down.
2. Fit jack to jacking points on a secure footing:
•
Front wheel left/right:
, see symbol
•
Rear of vehicle left/right:
Fig. 108-B
, see symbol
3. Raise the corresponding axle side and check the vehicle once again for
stability.
4. Remove the wheel bolts and remove the wheel.
Mounting
1. Fit the wheel on the centring hub and tighten all wheel bolts slightly.
2. Jack the raised axle side down.
3. Tighten the wheel bolts crosswise with a torque wrench. The permissi-
ble tightening torque is: 130 Nm
4. The wheel bolts must be tightened again as described above after
approx. 50 operating hours.
Danger
•
Risk of accident! Repair work on tyres and rims may be undertaken only by skilled personnel or
authorised workshops.
Warning
•
When changing wheels, make sure that the jack is applied to the specified jacking point.
•
Damaged tyres and/or incorrect tyre pressure reduce the operating safety of the vehicle. There is
a risk of an accident with tyres with too low or too high tyre pressure!
•
Check the wheel nuts regularly for firm seating. After a tyre change check the wheel nuts after
50 km and tighten them if necessary.
Fig. 108:
B
B
A
A
Summary of Contents for 147015
