Installing the Encoder
Resetting the Encoder
Makito User’s Guide, v2.1.0, Issue 01
54
Resetting the Encoder
This section describes the procedures to perform either a Power Reset or Factory Reset.
•
A
Power Reset
is equivalent to simply powering the unit off and on.
•
A
Factory Reset
powers the unit off and on, and returns the encoder to the same
settings it originally had when shipped from Haivision, including the factory default IP
address, subnet, and gateway.
After a Factory reset, only the firmware revision, serial number, and MAC address are
preserved. Everything else is wiped out (including saved configurations, added user
accounts, modified passwords, and encoding settings).
To reset the Makito:
1.
With the encoder on, insert a small plastic tool into the small opening labeled
Reset
on the Makito faceplate.
Figure 2-18
Reset micro switch (Sample view)
Power Reset
2.
For a power reset, press the micro switch (you will feel the button depress) for at least
one second and release. Be sure to release the button in less than 5 seconds.
This resets the unit.
-or-
Factory Reset
3.
To reset the Makito to its factory default settings, press the micro switch (you will feel
the button depress) and hold for five (5) seconds.
The Makito will reboot on its own. As soon as the lights stop blinking and the Status
LED is solid green, the encoder is ready.
