Installing the Encoder
Connecting the Encoder to A/V Sources
Makito User’s Guide, v2.1.0, Issue 01
41
Figure 2-8
Audio RCA to Terminal Dongle (unbalanced audio)
Modifying the RCA-Terminal Dongle for Balanced Audio
For balanced audio, you can modify the audio RCA to Terminal dongle provided in the
package to re-use the terminal block connector.
To modify the RCA-Terminal dongle for Balanced Audio:
1.
Remove the cover from the terminal block connector.
2.
To release each wire, use a flat screw driver and push it in the rectangular area. (The
terminal block has tension clamp connections.)
3.
Pull each wire to remove it from the terminal block.
4.
Prepare your new audio wires by removing about .150 inch of the wire’s insulation.
5.
Insert the new wires by pressing the tension clamp and then removing the screw
driver to release the tension clamp.
Refer to
“Audio Terminal Block Connector Pinout”
for the balanced/unbalanced audio
pinout.
Red - Right Channel In (female)
White - Left Channel In (female)
Terminal Block
Press apart the side clamps and
lift the top part off the terminal block
Use a flat screw driver to push the square
to release the wire