SECTION 9 –
MISCELLANEOUS
9-17
Each boom stand has a leg with a “foot” on
the bottom and a hex bolt in the top hole of
the leg to secure it from sliding off, as well as
a “snap” lock pin in the hole (located directly
below the bracket) to maintain it’s position.
120/132’ Spray Booms
Your boom is featured with two (2) boom
stands (located on the transom).
To Extend Booms Stands:
1. Remove Lock Pin (located on the outer
side of transom frame) and set aside.
2. While supporting the bottom “foot” end
of boom stand, remove the Mounting
Bolt (located on the outer side of transom
frame) and slowly lower boom stand to
desired position.
Boom Stand Assembly
-Typical View
Booms Stands
(120/132’ Boom)
-Typical View
Lock Pin
(Located on the outer
side of transom frame)
-Typical View
Lock Pin Removed
-Typical View
Summary of Contents for STS12i Combo
Page 276: ......
