9-30
SECTION 9 –
MISCELLANEOUS
15. Repeat Step 15 on opposite side, ensur-
ing 24” (61 cm) distance.
16. Once proper distance is achieved, hand-
tighten top and bottom Anchor Bolts of
each center Brush Guard Rail.
17. If necessary, remove the Front Fill Valve
Bolt (using a 1/2” wrench) and set aside.
NOTE: If Front Fill Valve is already oriented
correctly, proceed to Step 23.
18. Rotate the Front Fill Valve 180° (valve
handle facing toward front of machine)
and reinstall bolt.
19. Lower Front Fill Assembly.
20. Starting at the bottom, install Brush
Guard Tubes to Brush Guard Rails,
securing with U-Bolts and tightening
with a 1/2” wrench.
NOTE: Ensure U-Bolts are not over-
tightened. If the bolts are snugged too
tight, the brush guard extensions will
not extend properly.
NOTE: Ensure the Brush Guard Adjustment
Clips located on each end of tube are
facing upward when installing.
-Typical View
-Typical View
Front Fill Valve Bolt
-Typical View
-Typical View
Summary of Contents for STS12i Combo
Page 276: ......