SECTION 9 –
MISCELLANEOUS
9-33
Mounting Plate/Bolt Installation
(Severe Duty Legs)
-If Equipped
NOTE: If your machine is not equipped with
Severe Duty Legs, proceed to the next
numbered step.
6. Slide Crop Divider into mounting plate,
as shown.
NOTE: Ensure the hook end of the Crop
Divider is facing outward.
7. Install two (2) Crop Divider Mounting
Bolts through Crop Divider mounting
plate and tube. Install two (2) nuts and
tighten with a 3/4” wrench or socket.
8. Repeat steps to install remaining Crop
Dividers.
Installing Wheel Covers
1. Remove two (2) lug nuts from two (2) of
the wheel bolts and set aside.
2. Install Hub Cap Adapter Plate onto the
two bolts, as shown in the following
photo.
3. Reinstall the two lug nuts onto bolts and
tighten to with a 30 mm air wrench.
Refer to “Service - Bolt Torque” pro-
vided in the
Maintenance and Storage
Section
elsewhere in this manual for fur-
ther information.
Mounting Plate/Bolt Installation
(Severe Duty Leg Option)
-Typical View
• Crop Divider
Mounting Plate
Installed Crop Divider
-Typical View
NOTICE
Remove two (2) lug nuts at a time from
the wheel bolts when installing the hub
cap adapter plates.
Crop Divider Mounting Bolt
-Typical View
Summary of Contents for STS12i Combo
Page 276: ......