Hach Ultra POLYMETRON 9210, Operator'S Manual

Page: 63 / 116

Page 57
SILKOSTAT 9210
The following table shows the different alarms :
•
Warning : the analyser emits a warning at the display and on the warning
relay.
•
System alarm : the analyser locks the system alarm relay, displays a
message ant stops.
Displayed message
(english)
Description Category
Reset mod. Measure Reset of the measure module System
Reset module LC Reset of the local controller
module. System
Error lc Error of the local controller
module System
Err. measure mod. Error of the measure module System
Com error Error CAN communication System
Table error Error during transmission the
table System
Error task Error of the task execution System
Measure error Error of the measure Warning
Reference error Curent del adaptation problem Warning
Extinction error Extinction del problem Warning
Meas.time over Cycle time of the measure is
very long Warning
Cal.time over Cycle time of the calibration is
very long Warning
No sample No sample here System
Sample default x Short sample x Warning
Reagent < 250 ml Low level of the reagent Warning
Cal.sol < 300 ml Low level of the calibration
solution Warning
Low reagent Empty reagent canisters <150 System
Slope drift Confirmation zone Warning
Zero drift Confirmation zone Warning
Zero default
Rejection zone for the zero
calibration
System
Offset zero Rejection zone for the slope System
Sample x < C Sample concentration x is < to
threshold C Warning
Sample x < 0 ppb Sample concentration x is
negative Warning
Sample x > 1000 ppb ou
> 5000 ppb Sample concentration too high Warning
Reference error. Incorrect reference
measurement Warning