Command Manual – MPLS Basics
H3C S9500 Series Routing Switches
Chapter 1 MPLS Basics Configuration Commands
1-20
// Process by calling the signaling protocol.
*0.92041801 PE1 LSPM/8/LSPM POLICY:
Route added successfully
// Add a route successfully.
*0.92042024 PE1 LSPM/8/LSPM POLICY:
LSP added, VRF:0 Destination: 0x8c010101 Destination mask: 0xffffffff
Nexthop:0x7f000001 IfIndex:0x150000 LSPIndex:0x2446.
// Add an LSP.
*0.92066067 PE1 LSPM/8/LSPM POLICY:
LSP added, VRF:0 Destination: 0x8c020202 Destination mask: 0xffffffff
Nexthop:0x8c0c0102 IfIndex:0x300010 LSPIndex:0x2447.
// Add an LSP.
*0.92066083 PE1 LSPM/8/LSPM POLICY:
LSP added, VRF:0 Destination: 0x8c030303 Destination mask: 0xffffffff
Nexthop:0x8c0c0102 IfIndex:0x300010 LSPIndex:0x2448.
// Add an LSP.
# Enable MPLS process debugging by executing the
debugging mpls
management
process
command.
Start two switches, connect the two switches, and configure MPLS and MPLS LDP for
them to establish a session between them. Enable MPLS process debugging by
executing the
debugging mpls management process
command on one switch while
executing the
reset mpls ldp all
command on the other.
<PE1>debugging mpls management process
<PE1>
#Dec 22 17:05:57:766 2005 PE1 LDP/5/SessionDown: Session(140.2.2.2:0. public
Instance)'s state change to Down
// Restart the opposite end, and the Session is down.
*0.25271766 PE1 LSPM/8/LSPM PROCESS:
Rcv delete lsp msg from signaling protocol 0x8c010101/0xffffffff !
// Receive an LSP Delete message from the signaling protocol.
*0.25271766 PE1 LSPM/8/LSPM PROCESS:
Rcv delete lsp msg from signaling protocol 0x8c020202/0xffffffff !
// Receive an LSP Delete message from the signaling protocol.
*0.25271766 PE1 LSPM/8/LSPM PROCESS:
Rcv delete lsp msg from signaling protocol 0x8c030303/0xffffffff !
// Receive a Delete LSP message from the signaling protocol.
*0.25271844 PE1 LSPM/8/LSPM PROCESS:
Received Signaling message.
