Page 35
Issue 07/2011
Installation of generator
Installation of generators of model 132
Alignment
Important
y
Using the utmost care, align the drive shaft
to prevent damage to the generator and the
drive unit itself caused by excessive forces
during operation.
y
Ideally, align the drive shaft with laser
equipment. The drive shaft can also be
aligned and checked with a dial gage, ruler, or
a spirit level.
Maximum permissible offset values and forces
ð
Manufacturer documents of the drive unit and
drive shaft.
Maximum permissible forces on the generator
shaft
ð
Assembly instructions for belt drive:
Generators of model 132
ð
Section 3.5.1, page 31.
Generators of model 160
ð
section 3.6.1, page 42.
The permissible lateral offset is dependent on
the length of the intermediate pipe.
It is computed from the following formula:
ΔKr = tanα x AB, where AB = A-2 x N
General assembly of and disassembly instructions
y
Do not form the metal bellows beyond the permissible values.
y
Avoid any use of force.
y
The shafts and holes of the driving collars to be connected must be dirt-
and burr-free.
y
Check the shaft connection dimensions and the tolerances.
y
Oil the shaft journals: makes assembly of and disassembly of easier.
Lateral offset
Axial offset
Angular offset
A
AB
N
N
KR
Lateral offset
Summary of Contents for DWG (BL) 13/7-2 ZE
Page 87: ...Page 87 Issue 07 2011...
